SILENT KNIGHT 5084 Instrukcja Instalacji Pobierz pdf (Strona 36)

Operation Modes

151174 4-3

4.2 Operating Modes

This section gives step-by-step instructions for each mode. It is recommended that you read

through Section 4.1 and the Operating Mode steps once to become familiar with the

procedure. After you are familiar with the procedure you may find the Quick Chart easier to

use. (See Section 4.3.)

4.2.1 Operation Mode 0:

System Options

In Operation Mode 0 system options can be programmed. System options are; access code,

rotary dialing, usa rotary, speaker on/off, hide codes, * before 6, PBX access #, user number

length, call length, door time, aux time, system message, CIC #, aux relay enable/disable and

aux time window enable/disable.

To enter Operation Mode 0:

1. Press * then 0.

The display will show ACCESS #.

2. Enter the 6-digit access code. (Factory default is 123456.)

The display will show SYSTEM OPTIONS

3. Press *.

4. The display will show ACCESS CODE

XXXXXX. (X = a number from 0-9.)

5. Enter new 6-digit access code then *.

If you don’t wish to change the access code just press *.

6. Display shows ROTARY DIALING ?

YES or NO.

YES = rotary dialing NO = TouchTone dialing

7. Press any key other than * or # to toggle between yes or no.

8. Press *. The display shows USA ROTARY ?

YES or NO.

YES = USA rotary standards NO = EURO rotary standards

9. Press any key other than * or # to toggle between yes or no.

10. Press *. The display shows SPEAKER ON ?

YES or NO.

YES = speaker is “on” while dialing

NO = speaker “off” during dialing

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 57 58

Brak uwag

SILENT KNIGHT 5084 Instrukcja Instalacji Strona 36